e flite 6 channel ccpm transmitter manual

When you’re finished, here’s what your model will have: Check other areas of the site for more information as to how to load OpenTX onto your transmitter, or upgrade its version. The instructions will be specific for a FrSky Taranis X9D transmitter running v2.0 of the firmware, however should be close enough for any other transmitter running v2.0 of the OpenTX firmware. This lesson is to teach you how to program a very basic helicopter model into the OpenTX transmitter. Your transmitter battery is charged and so is your RC helicopter’s battery, but how do you get the transmitters sticks and switches to make your RC helicopter fly? Read on. The manual is written in Hieroglyphs, possibly translated from Swahili. You have your OpenTX transmitter, and your brand new RC helicopter and want to get it flying. You may wish to print this article, because it can serve as a complete checklist as you work through the programming. Allocate plenty of time to get through it if you have not played much with a Taranis radio. If you haven’t read it, especially if you’re new to helicopters, go back and do so, as what follows probably won’t make much sense if you don’t.Īn upfront warning, this is a long lesson. Your instructor: Craig (Fig ArchmageAU on RCGroups and HeliFreak )įor a downloadable PDF copy of this lesson, please click here: BasicHeli1 IntroductionĪs you are here, I assume you have read the “ TX Helicopter Model Basics”, so I will not go over that information again. Creating a Basic Helicopter Model (Part 1/3: Getting Setup)

E flite 6 channel ccpm transmitter manual